HOW TO FIX SPALLING CONCRETE

Source:www.stonediamondtool.com Date:2020/2/25 Read:274

What is concrete spalling and how do you fix concrete spalling? Don't replace your driveway, patio or basement floor—just resurface it. Read on to learn how to fix spalling concrete.

Get rid of concrete spalling by resurfacing the concrete

If your driveway surface has spalling concrete, the most likely cause is an installation mistake. Common mistakes include adding too much water to the mix, to make it easier to pour; sprinkling the surface of the concrete with water, to extend finishing time; and not curing the concrete properly after installation.

Resurfacing your driveway, patio or basement floor with a 1/2-in. concrete overlay fixes the problem. Enlist a couple of helpers and overlay the concrete surface one section at a time. A section is an area about 10 x 12 ft. that is defined by the existing control joints. Before starting, power wash the entire surface and brush it with a stiff broom and a cleaner/degreaser concentrate available from the hardware store.

The technique we show below can be modified for resurfacing concrete patios and basement floors.

Here’s the short course on how to install a concrete overlay:

Stake 1×2 furring strips along the edges of the driveway or patio, keeping them 1/2 in. above the existing surface. “Picture frame” the section by nailing 1/2-in. plywood strips, flat to the concrete, along the control joints.

Mix one part Type 1 Portland cement and one part fine sand by volume. Add water until the mixture is the consistency of thick paint, then brush it on the damp concrete.

Before that dries, mix three parts fine sand and one part Portland cement in your wheelbarrow with enough water to make the mix the consistency of thick oatmeal. Shovel the mix into the formed area and level it with a straight 2×4 spanning from one side of the forms to the other.

Smooth the surface with a bull float, round the edges along the forms with an edger, and finish the surface with a finishing broom. Timing is the secret to getting a nice finish. Use the bull float immediately, but wait until the concrete stiffens before using the edger and broom. All the tools you need are available at most rental stores. Cover the finished concrete with plastic for five days or spray it with a curing compound.