Eight steps to cast in place concrete countertops with glass embeds

Source:www.stonediamondtool.com Date:2021/12/6 Read:165

Step 1: Make the mold

Prepare your countertop mold and apply release agent to the forms. If you want glass presence in the edge details, toss glass chips up against your edge forms before placing concrete.

Step 2: Pour and Vibrate

Place your concrete mixture into molds and lightly vibrate the forms and concrete to consolidate the concrete. Consolidated concrete is denser and less porous resulting in less shrinkage cracks and improved stain resistance. On most projects I use an integral colored concrete mixture (Davis brand Sandstone and Adobe are the most popular).

Tip: Add an acrylic fortifier to your mix. Use of an acrylic fortifier to the concrete mix helps glass chips adhere to the concrete. Acrylic fortifiers also improve resistance to water penetration.

Step 3: Rough Finish

Bull float the concrete to smooth out the surface, but don't rough trowel or finish trowel just yet.

Step 4: Seed the glass

Spread the glass out evenly on your concrete surface using whatever quantity, colors, and mixes that you desire.

If you are using varying size glass chips, apply the larger sizes first, then medium chips and finish off with the smaller chips.

Here's a fun one: They now have glow in the dark glass! Try some in your counter mix as an inexpensive conversation stimulator.

Step 5: Tamp and Trowel

Carefully tamp the glass down into the top surface of the concrete mixture with a wood float. Lightly trowel the glass into the concrete gently pushing the glass into the still wet mixture until all glass is covered with the cementitious cream. Take care not to push the glass too deep into the mixture or you will have an uneven glass presence and the grind, hone, and polishing process can take much longer.

Step 6: Cure the concrete

Allow the concrete to cure for approximately 7-14 days depending on atmospheric conditions. Attempting to finish the surface too early will damage the surface and send glass chips flying. Finishing the surface too late will take much longer and will put undue wear on your finishing tools. Any cure time between 7-28 days is acceptable.

Step 7: Grind, Hone and Polish

Heavy-duty polishing tools are equipped with progressively finer grits of diamond-impregnated pieces or disks (similar to sandpaper) to gradually grind down the surface until the desired amount of glass and stone is revealed. I prefer to use a multi-head polisher rather than a single head polisher for a swirl free finish on the top surface. "Wet" grinding, sanding, and polishing reduces the amount of dust you will be exposed too compared with a dry grinding process. Take time with each progressive level of sanding using finer and finer grits until the sheen you desire is accomplished.

Tip: Be patient with each level of polishing grits. If you rush to the next finer grit too soon you'll burn through those expensive diamond-tipped polishing pads too quickly.

Step 8: Seal the Surface

After allowing the counter to cure at least 28 days and dry completely from the polishing process, apply the sealer, or combination of sealers that best suit your needs

Tip: If you seal before the counter is completely dried out a milky cloudiness can appear below the sealer and taint the appearance of your finished piece.

If you are using varying size glass chips, apply the larger sizes first, then medium chips and finish off with the smaller chips.