Structure of Diamond Saw Blades

Source:www.stonediamondtool.com Date:2010/5/18 Read:1837

 Diamond Saw Blades Stone processing blocks, plates, decoration of a tool most frequently used, its structure is broadly divided into non-outlet side of the whole ceremony, a narrow outlet-style, wide-outlet-type three.

1) the whole side of the outlet-free)

Matrix is usually non-outlet, the outer edge of the diamond is continuous, and sometimes have made of corrugated or oblique teeth, smaller diameter, generally in the 50 ~ 300mm, is the first metal powder and diamond mixture through the Cold molding, and then in the Well-type electric furnace or electric furnace heated by heat sintering; also useful graphite mold forming a direct hot-pressing. This has a cutting blade with a small stone.

2) narrow outlet type

Saw such a narrow outlet, the outlet is usually the key to make eye-type, the general board for sawing and trimming hair, the diameter of the saw blade is less than 700mm below the maximum use of this outlet for sawing marble, granite and Slate edge of the plate and the CD, but also for processing special-shaped stone.

3) wide-outlet type

Outlet width, in favor of Chip and cooling, high speed sawing stone blocks are the type commonly used. Usually in the size of 700 ~ 2200mm, has now made a large 5000mm diameter blade, into a group of circular saw blades is the use of such forms. Such as is now produced in a shaft 100 installed in 1600 ~ 2200mm diameter circular saw blades. Special application of a small diameter of the outlet width of the saw blade type, such as cutting non-slip trough, cut roads, machine planed boards.

Blade factory in recent years, developed oblique teeth, round teeth, tooth edge expansion, Chip teeth, tooth cavity and other forms of diamond circular saw blades, a lot of processing to solve problems.
In short, the choice of stone processing with circular saw blades to understand the different characteristics.